Jackets & coats · Advanced
Bomber jacket sewing pattern
Bomber or varsity jacket with knit cuffs and hem.
Choose your size
Each size has its own page with the full pattern, the cutting list and the measurements used.
Women's sizes (with bust)
Pattern preview
You will also need: lining, ribbing.
Sewing instructions
General steps to sew this garment. Seam allowance is 1 cm (3/8") unless stated otherwise.
Supplies
- Woven fabric (cotton, linen, poplin…)
- Lining fabric
- Ribbing for cuffs and neckline
- Separating zipper
- Matching thread and the right needle
- Prewash and press your fabric before cutting so it will not shrink after sewing.
- Print the pattern at 100%, check the test square and cut the pieces following the cutting list. Transfer notches, darts and button marks.
- Make the welt or flap pockets following the marks, before joining the main pieces.
- Assemble the shell: back, side and shoulder seams; press each seam as you go.
- Set the sleeves in flat: match the top of the sleeve cap to the shoulder seam and ease the cap between the notches.
- Sew the underarm and side seam in one go, matching the armhole seams.
- Close the rib cuffs and hem band into loops, fold them in half and sew them on, stretching them to fit the garment.
- Assemble the lining like the shell, attach it to the facings and bag it at the hem, leaving an opening to turn.
- Sew the separating zipper to the center front, right sides together, and topstitch 3 mm from the edge.
Cutting list
| Piece | Cut | Material |
|---|---|---|
| Front | 2× | Lining |
| Back | 2× | Lining |
| Yoke | 2× | Lining |
| Lining back | 2× | Lining |
| Sleeve | 2× | Lining |
| Sleeve | 2× | Main fabric |
| Waistband | 1× | Ribbing |
| Waistband ends | 2× | Main fabric |
| Pocket welt | 2× | Main fabric |
| Collar ribbing | 1× on the fold | Ribbing |
| Pocket bag front | 2× | Main fabric |
| Pocket bag front | 2× | Lining |
| Cuff | 2× | Ribbing |
| Lining front | 2× | Lining |
Measurements needed
| Measurement | How to measure |
|---|---|
| Biceps circumference | Around the widest part of the relaxed upper arm. |
| Chest/bust circumference | Around the torso at the fullest part of the chest, tape level. |
| Shoulder to bust | From the high point of the shoulder (next to the neck) to the bust point. |
| Back length | From the high shoulder point, down the back, to the waist. |
| Neck circumference | Around the base of the neck, where a shirt collar sits. |
| Shoulder width | From one shoulder point to the other, across the back. |
| Shoulder slope | Shoulder angle in degrees (usually between 10 and 15). |
| Waist to armpit | Vertically along the side, from the waist to the armpit. |
| Waist to hips | Along the side, from the waist to the hip line. |
| High bust circumference | Around the torso, under the armpits and above the bust. |
| Hip circumference | Around the hips, at the level of the hip bones. |
| Front length | From the high shoulder point, down the front, to the waist. |
| Bust span | Horizontal distance between the two bust points. |
| Waist circumference | Around your natural waist, the narrowest part of the torso. |
| Arm length | From the shoulder point to the wrist, arm slightly bent. |
| Wrist circumference | Around the wrist, over the bone. |
FAQ
Is the bomber jacket pattern really free?
Yes. Every Kutopy pattern is free, with no sign-up and no watermarks. You can sew and sell what you make.
Which measurements do I need?
This pattern uses 16 body measurements. If you don't know them, pick a standard size or follow our measuring guide.
Does it include seam allowance?
Yes, it includes 1 cm (3/8") seam allowance (outer dashed line). You can remove it in the editor.
How do I print it at full scale?
In the editor pick your paper and tap "Download PDF". At home: numbered Letter or A4 pages you tape together. At a print shop or plotter: full size on one sheet, a 36" roll or large sheets. Always print at 100% and check the 10 × 5 cm test square.
