Men L (chest 100 cm)

Basic T-shirt pattern, men's size L (100 cm chest)

Fitted short-sleeve T-shirt for knit fabric. A great first project.

Basic T-shirt – Men L (chest 100 cm)
Full pattern with 1 cm seam allowance · 102 × 72 cm
3pattern pieces
4pieces to cut
≈ 1.25 ydof main fabric (60" wide)

Sewing instructions

General steps to sew this garment. Seam allowance is 1 cm (3/8") unless stated otherwise.

Supplies

  • Knit fabric (jersey, interlock or similar)
  • Ribbing for cuffs and neckline
  • Matching thread and the right needle
  1. Prewash and press your fabric before cutting so it will not shrink after sewing.
  2. Print the pattern at 100%, check the test square and cut the pieces following the cutting list. Transfer notches, darts and button marks.
  3. Cut with the greatest stretch running horizontally (around the body). Use pattern weights instead of pins so the knit does not distort.
  4. Sew knits with a serger or a stretch stitch (narrow zigzag) and a ballpoint needle.
  5. Join front and back at the shoulders, right sides together. You can stabilize the seam with clear elastic or a strip of selvage.
  6. Close the neckband into a loop, fold it in half lengthwise and sew it to the neckline, stretching it slightly more than the garment, matching quarter points.
  7. Set the sleeves in flat: match the top of the sleeve cap to the shoulder seam and ease the cap between the notches.
  8. Sew the underarm and side seam in one go, matching the armhole seams.
  9. Fold up the hems (sleeves and body) and stitch with a twin needle or zigzag so they keep their stretch.

Cutting list

PieceCutMaterial
Front1× on the foldMain fabric
Back1× on the foldMain fabric
Sleeve2×Main fabric

Measurements used in this size

MeasurementValueHow to measure
Biceps circumference35 cmAround the widest part of the relaxed upper arm.
Chest/bust circumference100 cmAround the torso at the fullest part of the chest, tape level.
Shoulder to bust28 cmFrom the high point of the shoulder (next to the neck) to the bust point.
Back length47 cmFrom the high shoulder point, down the back, to the waist.
Neck circumference38 cmAround the base of the neck, where a shirt collar sits.
Shoulder width45 cmFrom one shoulder point to the other, across the back.
Shoulder slope13°Shoulder angle in degrees (usually between 10 and 15).
Waist to armpit21 cmVertically along the side, from the waist to the armpit.
Waist to hips13 cmAlong the side, from the waist to the hip line.
Hip circumference84 cmAround the hips, at the level of the hip bones.
Waist circumference81 cmAround your natural waist, the narrowest part of the torso.
Arm length63 cmFrom the shoulder point to the wrist, arm slightly bent.
Wrist circumference17.5 cmAround the wrist, over the bone.

Between two sizes?

Standard sizes are a starting point. Enter your own measurements in the editor and the pattern is redrafted for your body in seconds, for free.

Open in the editor