Men S (chest 90 cm)

Raglan hoodie pattern, men's size S (90 cm chest)

Pullover hoodie with raglan sleeves and a kangaroo pocket.

Raglan hoodie – Men S (chest 90 cm)
Full pattern with 1 cm seam allowance · 93 × 174 cm
10pattern pieces
18pieces to cut
≈ 1.75 ydof main fabric (60" wide)

You will also need: ribbing.

Sewing instructions

General steps to sew this garment. Seam allowance is 1 cm (3/8") unless stated otherwise.

Supplies

  • French terry or sweatshirt fleece
  • Ribbing for cuffs and neckline
  • Matching thread and the right needle
  1. Prewash and press your fabric before cutting so it will not shrink after sewing.
  2. Print the pattern at 100%, check the test square and cut the pieces following the cutting list. Transfer notches, darts and button marks.
  3. Cut with the greatest stretch running horizontally (around the body). Use pattern weights instead of pins so the knit does not distort.
  4. Sew knits with a serger or a stretch stitch (narrow zigzag) and a ballpoint needle.
  5. Hem the kangaroo pocket openings, press the edges under and topstitch it to the front before sewing the side seams.
  6. Join the raglan sleeves to the front and back; watch the notches (double notch = back).
  7. Sew the underarm and side seam in one go, matching the armhole seams.
  8. Sew the hood center seam (or center panel to the sides), finish the front edge and attach it to the neckline matching center back.
  9. Close the rib cuffs and hem band into loops, fold them in half and sew them on, stretching them to fit the garment.

Cutting list

PieceCutMaterial
Front1× on the foldMain fabric
Back1× on the foldMain fabric
Sleeve2×Main fabric
Pocket2×Main fabric
Pocket facing2×Main fabric
Hood side4×Main fabric
Hood center2×Main fabric
Waistband1×Ribbing
Cuff2×Ribbing
Neck binding1×Main fabric

Measurements used in this size

MeasurementValueHow to measure
Biceps circumference31.3 cmAround the widest part of the relaxed upper arm.
Chest/bust circumference89.5 cmAround the torso at the fullest part of the chest, tape level.
Shoulder to bust26.1 cmFrom the high point of the shoulder (next to the neck) to the bust point.
Back length43.8 cmFrom the high shoulder point, down the back, to the waist.
Neck circumference34 cmAround the base of the neck, where a shirt collar sits.
Shoulder width41.9 cmFrom one shoulder point to the other, across the back.
Shoulder slope13°Shoulder angle in degrees (usually between 10 and 15).
Waist to armpit19.6 cmVertically along the side, from the waist to the armpit.
Waist to hips12.1 cmAlong the side, from the waist to the hip line.
Hip circumference75.2 cmAround the hips, at the level of the hip bones.
Arm length61 cmFrom the shoulder point to the wrist, arm slightly bent.
Wrist circumference16.6 cmAround the wrist, over the bone.
Head circumference56.8 cmAround the head, above the eyebrows and ears.

Between two sizes?

Standard sizes are a starting point. Enter your own measurements in the editor and the pattern is redrafted for your body in seconds, for free.

Open in the editor